6

I have a Murray lawn mower (Model 20223X12A). The Tecumseh engine model number is TVS 90 4354K. I measured the blade diagonally and it is about 19.5 inches long. It is just a regular blade.

I wanted to know if I can install any type blade or brand as long as the length is the same. I was thinking of getting a 3 in 1 blade.

Improve this question
0

1 Answer 1

Reset to default
8

In principle, sure - as long as it will fit. Most blades are made to similar strength standards.

Check very carefully that the hole spacings are correct - and that you can tighten the bolt/bolts fully, as you really don't want a blade flying off at speed.

Improve this answer
2
  • Which hole spacing are you referring to? My mower has a bolt with a big washer that attaches to the shaft which holds the blade.
    – Rick
    Commented Feb 12, 2013 at 22:48
  • 1
    The ones that have a central bolt usually have locating rods or other devices. If it is a single bolt with no other fixings, then you have it easy :-)
    – Rory Alsop
    Commented Feb 12, 2013 at 23:21

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.