3

The picture below will describe this better than I can, but our 100 ft hose just blew apart at the faucet connection and it seems some piece that would go on the inside (maybe a rubber or plastic gasket?) fell out or inside the hose. I figured this should be an easy part to replace but have no idea what part/size I should be looking for. Don’t want to throw out a relatively new 100’ hose just for one small part!

Photo of hose end after it fell apart

UPDATE:

See Polypipe Wrangler's answer below... And here's a picture that shows what he's talking about. I was able to use a wire to pull this out and will try to find a way to secure it better so it doesn't blow out again.

Inner tubing scooped out and reconnected

  • 1
    very excellent question & illustrations & repair development!! – M H Jul 21 at 17:38
2

The metal part you are holding is the outer non-kinking protective pipe. There should be a flexible rubbery tube inside. I hope it hasn't retreated far down the pipe because it has to go over the barb on the fitting shown.

Once the tubing is on, then you can see if it just compresses against the outer pipe (most likely) or needs a special part.

| improve this answer | |
  • 1
    I shone a flashlight down the hose and finally could tell what you were talking about here! The inner hose was down a good foot or so and I was able to scrape it back up with a wire. – justanotherguy Jul 21 at 15:53
  • excellent solution & repair suggestions and repair developments!! – M H Jul 21 at 17:37

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.