5

I have a half-inch compression end cap attached to some half-inch tubing. The compression end cap is similar to this one: http://www.homedepot.com/p/DIG-1-2-in-Compression-End-Cap-Q58/100125237

I haven't been able to work out how to get the tubing out of this so I can reuse it. Any ideas?

7

If you wiggle the fitting from side to side while pulling, you can get it to step itself off the irrigation tube. This works for all sizes of these type push-in drip irrigation compression fittings.

The tube itself might not reseal if you push another fitting on, but the fix is simple for the tube, cut off the marred surface or push on a little further.

The fitting is made of harder plastic than the Polyethylene tube or dripline so it comes out of the equation pretty unscathed and reusable.

2

Soak the connecting points in a big pot of boiling water. I did it right on the stove. Then pull with pliers. It worked for me. Pull hard and maybe re-soak after it budges a bit to finish getting it out.

1

If you can afford to lose some of the length of the tubing, remove the screw on cap and cut the tubing and then push it through and out the end where the cap was.

If you don't have the luxury of removing a cap, then either of the above methods work - or you can cut the tubing and then grab it with a pair of needle nose pliers (with one side in the tubing and the other outside) and twist the pliers to wrap the tubing around them - this reduces the diameter and lets you pull out the tubing.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.